Author Topic: Zenith MicroTouch 2G - Platter Removal  (Read 548 times)

MagMan

  • Newbie
  • *
  • Posts: 24
    • View Profile
Zenith MicroTouch 2G - Platter Removal
« on: October 26, 2017, 05:00:48 PM »
I would appreciate some help in removing the platter of my Zenith MicroTouch 2G, model #169-353. I believe this model was made in house at Zenith. I've read the threads regarding the removal on this forum, and a few others, but just can't get the platter to lift off.  The two allen set screws appear to have already been removed, but my eyes aren't what they used to be. I can lift the spindle up, but only as far as the platter will lift up, about 1/2 to 3/4 inches. There's a plate and washer just below the 45 assembly which appears to be preventing it from lifting up. I've read where some models have a c clip, but it appears to a washer, not a clip. Any suggestions will be most appreciated, thanks.


There are any comments for this topic. Do you want to be the first?